RF modulator

An RF modulator (or radio frequency modulator) is an electric device whose input is a baseband signal that is used to regulate a radio frequency source. RF modulator History Before the debut of specialised video trimmer criteria like SCART, TVs were developed to simply accept signals through the aerial connector: […]

Receiver Front-End Noise Modeling

Applied at the transmitter as enteredsignal, suffered the connection losses and distortions (such as Cable attenuation, dispersion, evaporating( and reflections), and then was recovered by The demodulator or detector in the receiver department. After the signal reaches the Detection stage, it is accompanied by an extra signal voltage which changes […]

Video Bandwidth and Spectrum Considerations of Color TV

The screen resolution is set by the amount of picture elements (PELs). The Ratio between the horizontal and the vertical dimensions of the picture is 4/3 and can be Known as the aspect ratio. Hence, the amount of PELs rises by a factor of 4/3. Since the scanning routine is […]

Introduction to CATV Standards and Concepts of Operation

In preceding phases. HFC system transport consists of digital data and video data.9 The video data can be in either digital or analog modulation scheme. In this Chapter, the idea of television and its own signal structures will be reviewed. Community Access television (CATV) tests will probably soon be evaluated […]

Basic Structure of Optical Transceivers

The Objective of a optical transmitter would be to convert an electrical signal to some Modulated optical signal. These requirements specify digital transceivers Too as analog receivers and transmitters. But they differ from each other from Regard of layout requirements and design factors, irrespective of digital or analog. The digital […]

Cable television headend

Even the head end centre is normally unstaffed and surrounded by some kind of security fencing and is typically a building or large discard home electronic equipment used for and retransmit video over the neighborhood cable. One can also find headset endings in power line communication (PLC) sub stations and […]

Satellite-TV Encoding and Encryption

At the broadcast center, the high-tech electronic stream of video travels via an MPEG encoder, which converts the programming to mpeg4 video of the suitable dimensions and format to the satellite receiver into your home. Encoding works along with compression to analyze each video frame and then eliminate redundant or […]

Digital television systems

The specific problem with global digital tv is quite a bit simpler compared to. Most electronic television approaches have been based on the MPEG transport stream standard, and also use the H.262/MPEG-2 aspect 2 movie codec. They fluctuate considerably in the particulars of the way the transfer stream is converted […]

Broadcast television systems

Broadcast television systems are partitioning or partitioning standards for the transmission and reception of both terrestrial tv signs. There were just three primary analog television systems being used across the globe until late 2010s (expected): NTSC, PAL, and SECAM. Now in electronic television (DTV), you will find four main approaches […]

Page 1 Page 2